Permobil c500 user manual. USA 2019-02-23

Permobil c500 user manual Rating: 8,6/10 487 reviews

PERMOBIL C500 OWNER'S MANUAL Pdf Download.

permobil c500 user manual

Always make sure that the wheel locks are engaged after manually moving the wheelchair. The new Permolock features a Retractable Plunger or pin , ease of installation and stability. Permobil positioning belts are designed to position the user only and will not protect you in an acci- dent. Maybe a parts list image? Turn off the main power switch on the control panel. The screen for a shifted joystick is displayed for 5 seconds.

Next

M300 Corpus HD

permobil c500 user manual

Check the connections to the magnetic wheel Failure in wheel lock circuit Green lock. It is fitted with one screw - see figure. You may even receive further injury from the belts. Switch off the main power switch on the control panel. Remove the front wheel on the side in question, see page 10. Raise the seat to the highest position. If the chassis is equiped with fixed seat post, see page 38.

Next

C500 25 Manual Pdf PDF Book

permobil c500 user manual

Your wheelchair may also be equipped with an extra Seat Control Panel in addition to the control panel. Also, inspect the drive axle and wheel have the prescribed tire pressure. Magnetic wheel lock, wheel lock disk, cover and rubber seal disassembled. Both of the batteries are easily accessible for maintenance and battery replacement. Fax: +46 60 57 52 50 E-mail: info permobil. Information and specifics while transporting wheelchairs in vehicles while using the Permolock system are provided.

Next

WheelchairDriver • View topic

permobil c500 user manual

Remove the bolt, see fig. Permobil is not responsible for injuries or damage resulting from failure to exer- cise good judgment. Applies for electrical seat lift only. If it does, contact your Permobil serviceman as soon as possible. Lights and Reflectors In the standard version the wheelchair is equipped with reflectors in the front and back as well as on the sides. Operation of the wheelchair by users who exceed the maximum allowable user weight can lead to personal injury and property damage, including damage to the wheel- chair, as well as voiding any applicable warranty to the wheelchair.

Next

PERMOBIL C500 OWNER'S MANUAL Pdf Download.

permobil c500 user manual

Place the wheelchair on a level surface. If the tire is pneumatic, release the air. The Locking Plate is an easy-to-install docking station that holds the chair firmly and securely in position. The further you push the joystick from the center position, the faster the wheelchair will move. The new Permolock allows users to drive while sitting in their wheelchairs. To replace the charg- ing fuse, you must remove the main and front center chassis cover. The Retractable Plunger is first on the market to provide better ground clearance and prevents damaging thresholds or carpet.

Next

PERMOBIL C500 SERVICE MANUAL Pdf Download.

permobil c500 user manual

Remove the hub cap by pulling it straight out. The cause should be checked carefully before the Circuit Breaker is reset. If the chassis is equiped with fixed seat post, see page 38. The electric seat tilt actuator is controlled from the control panel or from the seat control panel. It is attached with three screws; see fig. Lift new batteries into the chassis using the battery belt.

Next

Permobil C500 standing wheelchair

permobil c500 user manual

Use the battery straps and connect new batteries in reverse order leave the straps on the new batteries. When you release the joystick the brakes are auto- matically applied. It is not designed to protect the user against injury while riding in the wheelchair in a vehicle. Raise the seat to the highest position. It is accessed through a hole in the chassis cover; see page 45.

Next

C500 25 Manual Pdf PDF Book

permobil c500 user manual

Raise the seat to the highest position. You may even receive further injury from the belts. Switch off the main power switch on the control panel. Driving The wheelchair has a drive pack for each drive wheel. Move the shaft sideways so that the belt becomes slack - see figure below. If your wheelchair is not equipped with lights option the push buttons for lights and turning indicators have no function.

Next